Taylor-Wilson pipe drifters

Printable Version

Fives tube pipe pipe drifters-FIVES

Pipe drift is a measure of the roundness or eccentricity of the inside wall of a pipe. "API drift" refers to primary specifications set forth in API specification 5CT (ISO 11960).

Taylor-Wilson range, automatic pipe drifting machine is designed to recognize the pipe length taken from customers quality and tracking system to control the stroke of the mandrel so that it does not extend completely through the pipe, yet meets the API drift requirements. A dial control at the operator's station will change the drift length to suit all pipe lengths.

The various sizes of drift plugs are interchangeable on one mandrel bar.

Operating principles

Pinch rolls drive the mandrel bar and drift plug into the pipe, once the drift plug is completely inside the pipe the drift speed is increased until the plug near the end of the pipe where the speed is decreased. The retraction of the drift plug will be done at high speed.

The drift speed is varied through out the drifting process; cycle times average around 25 sec, depending on pipe size and length.

The drift plug will rotate after drifting each pipe to distribute the wear on the drift plug evenly.

In the event that the drift plug jams in the pipe, the pinch roll unit will move backwards, along the axis of the mandrel bar tripping a limit switch and stopping the drive motor. A pipe removal plate is raised into position near the edge of the pipe, and the pinch rolls drive will and retract the drift plug. An alarm indicator will signal the operator of the plug jam.

A pedestal mounted operator's control station, complete with all necessary push buttons, selector switches, speed potentiometer, and an operator display to properly run the drift station in either a manual or automatic mode.

⇒ For recruitment-related matters (application, etc.), please do not use this form. Make your requests on this page.

In order to address your request, we need to collect the information listed in the form below

Information on data processing

As a data processor, FIVES implements personal data processing when managing your contact request. The data collected are required for this processing and are retained, unless you object, for a period of 6 months from the last contact between you and FIVES. If the information is incomplete, FIVES will not be able to respond to your contact.

The data collected are exclusively for the use of FIVES departments.

Pursuant to current legislation, you have the right to request access to data concerning you, their correction, deletion and portability, as well as a right of limitation over processing of your data.

These rights can be exercised by email to DPO@fivesgroup.com or by post to the Data Protection Officer at the following address: FIVES, 3 Rue Drouot, 75009 Paris, accompanied by a copy of an identity document.

In case of a dispute involving processing of your personal data, you have the right to make a complaint to the French Data Protection Agency (CNIL).

To find out more about our personal data protection policy click here


*

Despatch of these emails is managed by a FIVES partner located in the United States, an active member of Privacy Shield. The partner guarantees processing compliant with European requirements for personal data protection. Unsubscribe with a single click on a link in the message received.


* required fields

Your message has been sent and will be treated as soon as possible. Thank you for contacting Fives.

Sorry, we encountered a problem, your message was not sent